429 questions asked across 20 exam years, newest first

Answer: B
Two resistors and are connected in parallel. The equivalent resistance of their parallel combination will be :
Answer: C

Answer: C

Answer: C
A uniform heating wire of resistance is connected across a potential difference of . The wire is then cut into half and potential difference of is applied across each half separately. The ratio of power dissipation in first case to the total power dissipation in the second case would be 1 : x, where x is ____.
Answer: 4
If you are provided a set of resistances , , and . Connect these resistances so as to obtain an equivalent resistance of .
Answer: D
An electric bulb of at is used in a circuit having a supply. Calculate the resistance R to be connected in series with the bulb so that the power delivered by the bulb is .
Answer: A
The resistance of a conductor at is and at is . What will be the temperature coefficient of resistance of the conductor?
Answer: C

Answer: 60

Answer: 1

Answer: A
An inductor of 10 mH is connected to a 20V battery through a resistor of and a switch. After a long time, when maximum current is set up in the circuit, the current is switched off. The current in the circuit after is mA. Then x is equal to ____. (Take )
Answer: 74
A circular conducting coil of radius 1 m is being heated by the change of magnetic field passing perpendicular to the plane in which the coil is laid. The resistance of the coil is . The magnetic field is slowly switched off such that its magnitude changes in time as The energy dissipated by the coil before the magnetic field is switched off completely is E = ____ mJ.
Answer: 80
An electric bulb rated as 200 W at 100 V is used in a circuit having 200 V supply. The resistance 'R' that must be put in series with the bulb so that the bulb delivers the same power is ____ .
Answer: 50
A resistance is connected across AC supply. The time taken by the current to change from its maximum value to the rms value is :
Answer: A

Answer: A

Answer: C
A wire is bent to form a square loop. A 9V supply having internal resistance of is connected across one of its sides. The potential drop across the diagonals of the square loop is ____ V
Answer: 45

Answer: 500

Answer: C
Match List - I with List - II | | List - I | | List - II | |---|---|---|---| | (a) | | (i) | Current is in phase with emf | | (b) | | (ii) | Current lags behind the applied emf | | (c) | | (iii) | Maximum current occurs | | (d) | Resonant frequency | (iv) | Current leads the emf | Choose the correct answer from the options given below
Answer: A

Answer: 500
In an electric circuit, a cell of certain emf provides a potential difference of across a load resistance of . However, it provides a potential difference of across a load resistance of . The emf of the cell is given by . Then the value of x is ________.
Answer: 15

Answer: A

Answer: C